Lynx 2.1 revised pusher
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Revised vented pusher to fully chamber darts and direct airflow onto the rear of the dart.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 20
- Makes
- 0
- Views
- 211
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
My lynx was getting a standard deviation of about 22 for a 20 dart average.
This mod replaces the screw head pusher with a longer ported pusher that fully chambers the dart into the barrel and directs airflow onto the rear of the dart.
This has improved the standard deviation to 5 for a 20 dart average.
However since the pusher is now longer the transfer bar needs to travel further back into the stock to allow darts to fully lift from the magazine.
To accommodate for the longer travel the butt pad needs to have a deeper well for the transfer bar. The butt pad included in the file set is a remix of genexis Lynx 2.1 exteneded butt and stock
In addition to achieve the increased travel a small pad needs to be glued to the rear of the slot in the transfer bar. This increases the travel by 10mm which is sufficient for the pusher to clear the mag well allowing the next dart to lift into the magazines feed lips.
I have only tested this using ZafC's high flow turnround but it should work with the standard turnround.
Prints fine with a 0.2mm layer height.