Ulanzi UKA09 anti-twist insert
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement for the too short anti-twist insert for slim camera bodies
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 4
- Makes
- 0
- Views
- 33
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
While some UKA09 anti-twist plates come with a rubber insert with "overhang", others have just a plain black piece of POM that does not reach the body on many slimmer cameras, e.g. Sony ZV-E1 or Sony A7C that have the tripod mount close to the front edge of the camera.
This insert was designed around the ZV-E1, but should fit other cameras too.
This insert replaces the original one. You have to remove the tripod screw (it just unscrews from the base), pull out the old insert and slide in the new one.
I recommend printing with at least 4 perimeters, 100% infill, and a bit hotter than usual for maximum layer adhesion. Use a stable filament with high layer adhesion, I would not use brittle or soft filaments. if you are filming, keep the heating of the camera in mind and use a high-temp filament.