Valve Index HMD Wall Mount

Modeled from scratch in Fusion 360. I'd print with at least 4 perimeters and with the orientation as shown in the model view to ensure rigidity. The one pictured was printed in PLA. Doesnt show any signs of flexing or breaking. The chamfered edges where the HMD rests are to try to match the curved slope of the HMD. Id suggest some self stick foam there to prevent scuffing the HMD. Its mounted to the wall with two of these or similar: https://www.homedepot.com/p/E-Z-Ancor-Twist-N-Lock-50-lb-Drywall-Anchors-with-Screws-25-Pack-25200/100133106

7/09/19: Updated the photos to match the final product and the model i actually uploaded. No changes to the model itself. So if you downloaded it already no need to reprint. The photos with the blue print were from a first revision test print. The one I uploaded ended up with thinner width rails and a flat chamfer for padding. I just never updated the photos. The print in the photo uses Atomic Filament Carbon Black PETG and uses this padding which fits the chamfer perfectly: https://www.amazon.com/gp/product/B000UZFO1U/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

The foam protects the HMD and keeps it very secure from sliding.

7/09/19 (2): Designed and added a hook to hang the cable coil from. Print as oriented with 4 perimeters and 20% cubic infill. Use a few dabs of superglue to prevent it from rolling forward.

8/8/19: By request, I have added a split version. Print parts 1 and 2 and they connect at the middle. Supports recommended for the post end. May need to sand the surfaces to get them to fit together. I did not design in any tolerances due to how that varies between printers. Nail files make great sanding pads for small stuff like that. Probably want to super glue them together as well.

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

.35

Infill:

Filament: Any PLA

Notes:

Category: Gadgets