Improved General Grievous - Dummy 13

I have changed and edited almost every Armor part on this General Grievous Model.  I started out this project just wanting to print the figure to put in my office at work but I just wasnt happy with how some parts looked or how it went together. Here is a compilation of work not only by me but by all the designers that made the original parts.

I printed the Model at 170% the standard Dummy 13 size. Not sure how some of the armor pieces would print any smaller than that. Let me know if you try.

Note: The extra 2 arms do not get a shoulder joint, instead that shoulder joint is reused to attach the feet to the legs, this gives his legs the classic bird like look.

Here is where all the parts came from and the changes I made:

The Feet and Forarms and swords I took from this creator, I did not change them.
https://makerworld.com/en/models/1201894-dummy-13-general-grevious#profileId-1214989

The abdomen is from this model. I edited it to make the back the same height as the front.
https://www.printables.com/model/1286204-dummy-13-terminator-t800-armor

I used this 4 arms mod for the model.
https://makerworld.com/en/models/531614-4-arms-for-dummy-13?from=search#profileId-448463

The Knee and Shoulders were remixed from this model.
https://www.printables.com/model/23094-general-grevious-low-poly

The Mask was kitbashed using this model as the base, I also used the chest from this model and edited it.
https://makerworld.com/en/models/471528-grevious-13-model-3d-innovators-studio?from=search#profileId-381152

And finally all the remaining parts are either directly from the Dummy 13 Model or remixed from the base model.
https://www.printables.com/model/981111-dummy-13-version-10


I would really appreciate you posting your makes and commenting on the model. Let me know what you think and if there is something that doesnt fit/work properly.