1 / 3
Falcon A1/A1Pro Work area Consumable Holder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Designed to house 2 4x4mm magnets and hold your consumables in place, yielding consistent engraving results.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 14
- Makes
- 0
- Views
- 72
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed these consumables place holders to overcome a problem with my Falcon A1 Laser Engraver, sometimes i needed to check if the engraving was good enough, and moving the consumables means that youll not be able to place it back again in the exact same place causing a lot o headaches.
This helps keeping your consumables from moving and a placeholder so you always put back the consumable in the exact same spot and continue where you left.