Travel Cribbage Set

For the lines, I used waterslide decal paper with the attached PDF.

I also added a multi-body STEP file with simplified lines for multi-color printing.

These are the settings that worked for me with generic PLA on my QIDI Plus4.

• Crib & Crib w Lines

  • Print-in-place

  • 0.16 layer height

  • I used a brim because the snap-fit closure tabs wouldn't always adhere

    • Other adhesion methods would probably work

• Slide

  • 0.08 Initial layer

    • Critical for tiny dovetail feature

  • 0.10 Other layer height

  • Takes some force so snap into board

    • It helps to push in the center to flex the slide cover

• Peg

  • I printed small side down with large brim

  • SLOW it down, like 5mm/s