De'Longhi Pinguino PAC EX120 → 110 mm flex hose adapter (threaded)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Connects a De'Longhi Pinguino PAC EX120 to a 110 mm spiral flex hose. Snaps in like the original, hose screws in.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 21
- Makes
- 0
- Views
- 433
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Share Alike
Adapter for connecting a De'Longhi Pinguino PAC EX120 portable AC directly to a 110 mm spiral flex hose. The device side clicks into the receptacle on the back of the AC like the original duct fitting; the hose side has an internal thread — the hose spiral screws straight in.
Dimensions:
Hose thread: pitch 5.5 mm, 6 turns, crest-to-crest Ø 113.0 mm, bore Ø 118.2 mm — fits spiral hose with ~113 mm OD over the wire
Overall length ~137 mm, wall 3 mm
Note: necking down to 110 mm reduces exhaust cross-section vs. stock; works fine for a short straight wall passage
Printing: PETG or ASA (exhaust air gets 50–60 °C, no PLA for the final part). Threaded face down on the bed, brim is a must — the part stands tall on a thin ring of wall, without a brim it will come loose mid-print. 0.2 mm layers (0.12 mm for the bottom ~42 mm gives crisper threads), 4 perimeters, no supports needed except possibly the slanted beak at the top - mine worked without supports though. Tip: cut the model at 40 mm in the slicer and print a test ring to check the thread fit first — inner diameters vary by printer.