Simple Trash Bag Roll Holder ( 70mm Roll Diameter)

Simple two-piece holder for trash bag rolls.

Designed for trash bag rolls with a diameter of approximately 70 mm. Smaller rolls are also supported.

Tired of searching for garbage bags under the sink? This holder keeps the roll organized, visible and always within reach.

The design consists of two separate mounting brackets, allowing you to adjust the spacing for different roll widths.

No supports required. Fast print. Easy installation.

Simple Adjustable Trash Bag Roll Holder

A practical solution for organizing trash bag rolls inside kitchen cabinets, utility rooms or workshops.

Instead of keeping bag rolls loose in a drawer or under the sink, this holder keeps them neatly stored and easy to access.

Compatibility

The holder was designed around trash bag rolls with an outer diameter of approximately 70 mm.

Smaller rolls can also be used without any issues thanks to the open support design.

Because the holder consists of two separate brackets, the spacing can be adjusted to fit different roll widths.

Features

• Two-piece design

• Adjustable spacing for different roll widths

• Quick and easy installation

• No supports required

• Low filament usage

• Suitable for most common trash bag rolls

Printing

Recommended settings:

• Layer height: 0.20 mm

• Walls: 4

• Infill: No need

• Supports: No

• Material: PLA / PETG

Installation

1. Print both parts.

2. Adjust spacing according to your roll width.

3. Fix with screws to the cabinet door or wall.

4. Insert the roll and enjoy a cleaner storage solution.

If you print one, I would love to see your make!