Gardena / Husqvarna push reel mower pinion cog
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Pinion gears / cog for push mower, reel mower, cylinder mower. Replace and repair the worn plastic part in your mower.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 9
- Makes
- 0
- Views
- 73
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Longevity update, 2026-07-04:
Both of the pinion gears failed today during heavy use, 5 minutes between. This happened when pushing the mower hard through tall grass and moss. They basically delaminated between the solid base and the teeth. No models have been updated yet, but as a first change attempt I would print the cog at a 30-45 degree angle off the build plate, with support. I have added some pictures of the failed cogs. Will update again as I update the model and get more experience.
Original post:
Replacement pinion gear cog for your mower. There are two, and they are mirrored - check if this model is correct for the one you need, and just right-click and mirror it in PrusaSlicer to get it the other way. The model is the left side pinion (white on my mower), and if you need to replace the right side pinion (black on my mower) you need to mirror it. Double check the underside, or just print both from the 3mf file.
I replaced both at once on my mower, and cleaned and regreased the mechanics. My mower now works as new again.
When printing, remember supports under the flat base inside the part. Print in PETG or Nylon for best results. I printed in some old PET+ (similar to PETG) I had, at .2 layer height, 5 perimeters, and 40% infill.
My push reel mower hasn't been working as well as it should the past couple of years, because the wheels appeared to slip as I met resistance. I try to take care of my reel mower, making sure it can cut paper evenly across the entire cylinder.
After trying to find the problem, it appears that the inside of the pinion gears have been worn down at the corners where the internal pawl grips on when pushing, and this is why the wheels spin without rotating the reel. I've found replacements online, costing around €30 including shipping (and including new pawls, but the metal pawls are hardly worn).
I'm always practicing FreeCAD when I design, but I'm not very good. I was hoping to resolve this using the Part Design workbench and detailed measurements, and I made the base design carefully this way, but the final details were completed using the Part workbench.
I created this model in FreeCAD 1.1.1 based on detailed measurements of the originals, and the Gears workbench to get the involute gears right. I'm not a FreeCAD expert, so this design can surely be improved lots of ways.