40mm Fan to 50mm Heatsink - Mounting Bracket
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A super simple LSI 9300-8i fan mount bracket (Inspur for this design)
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 10
- Makes
- 0
- Views
- 64
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
This is a simple mount for adding a 40mm fan to a 50x50x11.2mm heatsink.
Print in ABS/ASA if you expect temps to get over 70c, though there's a chance PETG or even PLA could withstand it with the fan being in use. No supports required, but you do have to put the flat most face on the plate (I didn't change it before saving and exporting)
This was designed specifically for a Inspur LSI 9300-8i which comes with a square 50x50 heatsink that comes in at 11.2mm, card to top of the heatsink was 12mm, hence the small feet. I found a bunch of different mounts for fans but none that did the trick or fit on this heatsink perfectly.
I've included the Freecad file here as well as the STEP, STL, and 3mf. You can adjust the dimensions of this as you see fit, but I didn't do a very good job at keeping it a smooth and non destructive design. The base and legs should auto adjust fine, but the Linear Pattern will likely need adjustment on Direction 2 after changing the dimensions. You may also need to reselect edges on the following Filets and Chamfers. All in all, 3 minutes of work if need be.