Ryobi PCL705 Hand Vacuum 15mm Nozzle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A thin nozzle attachment to use for harder to get to places.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 8
- Makes
- 0
- Views
- 58
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
This is a three-piece nozzle with the black cap made from TPU. The nozzle tube is printed on its side for layer strength. It has a flat side for bed adhesion. No supports needed but there will be a little sag inside the tube. You can use support, but you will need to clean out the whole length of the tube. The bushing is recessed to match the tube flange and has a generous amount of surface area for gluing. For assembly glue the bushing in place on the tube. Next put glue on the bushing surface that mates inside the TPU cap. Slide the tube assembly into the cap until it stops. There is a ridge inside the cap, push the tube assembly about 3mm more to seat the assemble all the way down. With the glue and the retaining ridge, the whole assembly should be permanently in place. The TPU is slightly tapered to mate the vacuum for a tight fit.
I used either 3 or 4 walls on the tube. The cap is made from Ziro TPU 95A and the tube and bushing are made from Overture Grass Green matte PLA.