Cold air input adapter for QUBO Q40HD portable air conditioner
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adapter for a portable AC which turns it into an outside, almost split system.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 9
- Makes
- 0
- Views
- 82
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
Air in adapter for a portable AC - which comes in numerous names, but the overall shape is almost the same.
This model has been made for "EBERG QUBO Q40HD".
It turns it into outside almost split system, cools the the inside air sucked through the vent pipe connected to the adapter. Which makes the cooling more efficient (on paper, but it does sustain low temps better), and helps to keep almost all noice outside (results might vary, depending how far it's from the cracked open window, but it does help).
Other (possibly, I didn't verify the dimensions, going by the look alone):
Warmtec Morso KP40
Sinclair AMC-14P
Fral FSC14.2SC
Before starting the print you might want to measure the dimensions in slicer/Fusion and confirm it'll fit.
I've been using this for a second year, printed in PETG, left outside for the winter season and all looks good.
It requires M3 screws to put together:
9 screws to hold chassis pieces together
3 screws to attach pipe
4 screws to attach handle to chassis
The chassis prints in 4 pieces - at least if you use default STLs, it matches the Bambu A1 print bed size (256mm*256mm*256mm).
The included Fusion file can be used to tweak the dimensions, although I didn't parametrize it. The sketches should be more or less clean, but features like chassis slices and mounting posts are very specific and might require extra work to adapt them to smaller bed size.
The input vent is set to use 100mm elastic pipe, altough it can be easily resized. I've used slightly scaled down version of this model: https://makerworld.com/en/models/487870-quick-disconnect-ventilation-v3-by-oiass to mount the vent pipe. But I'd assume anything similar can be fitted in by tweaking the model in Fusion.
The handle has almost the same dimensions as the filter that's already in the device, and fits into the same slot. Though while inserting it the chassis might need to bend a little (that's why PETG or similarly non brittle filament is needed.
The chassis edges might not be air tight / snuggly fitting the AC chassis, but as air goes through the place of least resistance it'll mostly choose the vent pipe, sucking inside air for cooling. Using tape to seal it off could also work.
It forces us to ditch the filter, although if you place the input pipe in secure place (far from pets and their fur) it shouldn't suck too much dust. Or you could consider printing a mesh and add it under the pipe adapter to functionally substitute for the original filter mesh.