House plant hanging ring
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is designed to "convert" a typical indoor houseplant pot into a hanging pot. Resizable to suit your need.
- Rating
- 5 / 5
- Likes
- 11
- Downloads
- 36
- Makes
- 1
- Views
- 110
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This hanging plant ring is designed to "convert" any typical indoor houseplant pot (of a reasonable size) into one that can be hung from a hook, in front of a window, etc.
Features:
3 outer loops, to which you can tie string/cord (I used 3 "bowline knots" and some twine. You could use paracord, printable hooks, metal chains/hooks for hanging plants [see Amazon/hardware store] etc.)
An inner diameter of about 4.8", enough to hold a 5" pot towards the top for stability.
Another version has been added sized to support a standard 6" clay pot
A chamfered interior edge to maximize contact with the pot. This also allows it to be REVERSIBLE in case you need to tighten the fit by a few millimeters.
It is intended to place it with the chamfered/beveled edge facing UP typically.
Design can be scaled up or down to adjust the inner diameter for larger pots
Minimal filament usage, prints fast
Recommended to print with PETG for heat/sun exposure and some flexibility. I've had bad luck with PETG stringing when crossing supports, so a rectilinear infill as low as 5-10% and a 0.20 layer height worked well.
Updates:
V2 2026-07-09:
I heard you guys like filletting, so I had to figure out why and how and added that. Should be stronger in the corner joints, though the original design was already plenty strong and I couldn't snap the small rings off even if I tried. (pictures show v1, render is v2)
2026-08-15 new size:
Another version has been uploaded which is scaled to fit a standard 6" clay pot like you'd find at every garden center.