1 / 8
Slim Junction Box for Reolink RP-PCT8M / RP-PCT12M Camera — image 1
1 / 8

Slim Junction Box for Reolink RP-PCT8M / RP-PCT12M Camera

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A very low-profile 3D printed junction box for Reolink RP-PCT8M and RP-PCT12M cameras.

Rating
0 / 5
Likes
5
Downloads
12
Makes
0
Views
95
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Public Domain

This is a slim junction box I designed for the Reolink RP-PCT8M camera, and it also works with the RP-PCT12M. I wanted something very minimal and low-profile, so the box is only around 20 mm tall. This was about the smallest size I could make while still leaving enough room to fit the cables inside.

The cable space is intentionally very tight, so installation takes a bit of patience. You may need to carefully arrange and compress the cables inside the box while mounting the camera, but the result is a clean and compact look on the wall.

The print is designed with 4 embedded M4 nuts. In the included 3MF print project, I added a pause at layer 79. When the printer pauses, insert the four M4 nuts into their pockets, then resume the print. The next layer will cover the nuts and permanently enclose them inside the print.

To attach the camera backplate, use M4 screws:

  • Minimum length: 12 mm

  • Maximum length: 16 mm

In the 3MF version, I also added a small weep hole at the bottom. This is set up as a negative part in Bambu Studio, so you can remove it from the project/layers if you do not need it.

Tags