Tripod mount Rockseed laser measure s7
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A cradle to allow the Rockseed SS7 Laser Measure to be mounted to a standard tripod and to secure it in any orientation
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 17
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Share Alike
I wanted a way to mount my budget laser measure to a tripod and to secure it in any orientation. it locates on the four recessed holes that close the two halves of the case together and has a central hole for a 1/4inch thread and four M5 holes on the periphery to keep the retaining bracket in place.
The retaining bracket is a bit on the thin side, I printed mine in the orientation seen in the photo, with lots of support and it still feels fragile, I might remix this later to thicken the retaining bracket to 3mm sides and top and give the 4 cap head bolt holes some more meat around the outside.
I printed this out of PETG 15% infill, 3 walls and 0.2mm layer height though I did set the bottom thickness to 1mm like the top.
I had planned on using a modifier on each hole to help with tapping but the holes are sized for tapping and I was able to tap all 5 holes and it doesn't look to have damaged the part at all.
The v4 base does not have a socket for an M5 cap head screw which might be less fragile than the v6 base.