Cable Tie Holder with Magnetic Wall Mount / Kabelbinder magnetischer Organizer

Cable Tie Holder with Magnetic Wall Mount

A two-part cable tie organizer for your workshop. The holder has 8 compartments of different sizes and heights to sort cable ties by length and width. It attaches magnetically to a wall-mounted plate, so you can grab the entire holder, take it to your workbench, and snap it back when done.

Features

• 8 compartments — different diameters and heights to accommodate cable ties from small (100 mm) to large (300+ mm)

• Two-part magnetic mount system — holder snaps on and off the wall plate with one hand

• Wall plate mounts with 4 screws

• Compact footprint despite high capacity

• Holder dimensions: 127 × 90 × 250 mm

• Wall plate dimensions: 68 × 7 × 225 mm

Included STL Files

• Cable_Tie_Holder.stl — the main holder with 8 compartments

• Cable_Tie_Holder_Magnetic_Wall_Mount.stl — the wall-mounted plate

Required Hardware

• 16× neodymium disc magnets, 10 mm diameter × 3 mm height (8 in the holder, 8 in the wall plate — press-fit into both parts)

• 4× wood screws for mounting the wall plate

Print Settings

• Material: PLA or PETG

• Supports: None

• Layer height: 0.2 mm

Note: The holder is a tall print (250 mm). Make sure it fits your build volume.

Assembly

1. Print both parts.

2. Press magnets into the pockets on the back of the holder and into the matching pockets on the wall plate. Ensure correct polarity — the holder must attract the plate, not repel it.

3. Screw the wall plate to your wall, cabinet, or workbench side panel.

4. Snap the holder onto the plate and fill it with cable ties.

Why This Design?

Most cable tie storage is a drawer or a bag — which means digging around for the right size. This holder keeps every size visible and accessible, sorted by compartment. The magnetic mount means you don't have to pull ties out one at a time at the wall — take the whole holder to where you're working and bring it back when you're done.