1 / 4
21-23 fits Honda Ridgeline wireless charger — image 1
1 / 4

21-23 fits Honda Ridgeline wireless charger

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This was designed to replace the internals of the OEM charger to replace it with a magnetic "puck" charger with cooling.

Rating
0 / 5
Likes
4
Downloads
8
Makes
0
Views
124
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Noncommercial

Got sick of the OEM really slow charger that only worked sometimes. Designed this little insert to work with THREEKEY Qi2.2 Magnetic Wireless Charger: 25W Fast Charging Pad with Cooling Fan from AMZ.

You have to remove the wireless charger and its surround out of the truck (pry it up carefully in order to not damage center console).  From there remove the charger from the surround (4 screws and 4 tabs) and then take apart the charger (4 more screws and tabs).  This part takes place of the top and internal of the wireless charger.  It has a place to reuse the 4 screws that were last taken out to reassemble.  Then you put the assembly back in the surround.  To mount the wireless "puck", I used heavy duty 2 sided 3M tape.  Mount with the USB port towards the small notched out area on the underside, which is visible in one of the pictures.  

To power it, I took out the two screws holding the console part with the cup holders.  Underneath it, in the glove box is a small slotted hole.  On the backside of that, under the console part is a single screw that will remove a cover.  I plugged the power into the cigarette lighter in the console and ran the wire through that hole up through the console to the bottom of the wireless pad.  When you reinstall the console, take care to not pinch or damage the cord underneath it.  Snake the wire into the back of the new holder with the puck and plug it in.  Carefully reassemble the wireless charger with surround and snap it back in place.

With this setup the charger is only powered with the truck and no permanent modification is needed to the truck.

I printed this on my K2 Plus with ABS filament, facing down with auto tree supports and 50% infill to give it plenty of strength.  It probably would have been fine with less infill, but I am happy with how it turned out.