RaceBox Mini S Suction Cup Mount

This part is designed and optimized for ASA printing with a 0.6mm nozzle.

This is a redesign I made for mounting the RaceBox Mini S to the outside of my car using the Ansix Auto suction cup mount (which is just a generic suction cup mount with a 1" wide opening and a through bolt).

The redesign addresses a couple issues I had with their original part:

• Cannot pivot the RaceBox to the correct angle for exterior vehicle mounting on my GR86

• Cannot mount RaceBox in both orientations, 1/4-20 threaded hole is only on one side of the mount.

This improved part does require support material, but the finished product allows a more versatile mounting solution for the RaceBox Mini S. 

• Mount "forward" or "backwards" with the 1/4-20 screw hole on both sides of the mount

• Maintains USB-C hole for charging without removing from the housing

• Rotate RaceBox to 180 degrees, parallel with the suction cup mount

• Extends further away from suction cup base, so you can actuate the suction cup lever easier

Recommended Print Settings:

Plain ASA:

• X-Y Hole Compensation .1

• Walls: 4

• Brim: Outer Brim

• Infill: 15% (or higher) Gyroid

• Support Material: Yes

• Print orientation: Long side wall touching build plate

• Layer Height: 0.24mm (with 0.6mm nozzle)

• Speeds: Wall Speeds reduced to 150mm/s and 180mm/s for outer and inner respectively

Recommend to print with ASA-CF (Fiberon ASA CF-08 had great results with dimensional accuracy):

• No X-Y hole compensation

• Walls: 2

• Brim: None

• Infill: 15% (or higher) Gyroid

• Support Material: Yes

• Print orientation: Long side wall touching build plate

• Layer Height: 0.24mm (with 0.6mm nozzle)

• Support Interface Layers: 3

• Support Interface Spacing: 0.2mm