vacuum bagging frog
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Summary 1/4" I.D. hose vacuum bagging connector with straight port, no schrader valve, non-shear disk, and o-ring sealed
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 21
- Makes
- 0
- Views
- 164
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
Summary
1/4" I.D. hose vacuum bagging connector with straight port, no schrader valve, non-shear disk, and o-ring sealed breach. Or you could just call it a "frog".
Inspired by http://www.thingiverse.com/thing:61666 by DariusShekari
Used for expoxy vacuum infusion of ABS 3d printed parts. See additional images for the ultra cheap set-up :)
Instructions
0.3mm, 3 layer, 90% fill for Foot.
0.2mm, 3 layers, 25% fill for Ring and Nut
Made with or without rafts, no supports. PLA @ 240 C, feed 100 mm/s.
Use with -223 O-ring for seal.
Bag goes between o-ring and ring. Hole in bag should be snug around base of threaded stem of foot before tightening the nut.
Wipe clean before expoxy/resin sets. Drill hole if clogged. Gets better with each use. If used to full cure, throw foot away and print another.