Clipcade - a magwell for the Barricade (full or half dart)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A chunk of plastic that makes the nerf barricade mag-fed, no hardware needed.
- Rating
- 0 / 5
- Likes
- 17
- Downloads
- 19
- Makes
- 0
- Views
- 232
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Creative Commons — Attribution — Noncommercial
VERY early version! Expect issues.
Converts a Nerf Barricade to take magazines, since Barricades are WAY easier to find than Stryfes where I live. Also, quick warning, if I were you I'd print off the 42mm spacing version of this barricade flywheel cage, because with the stock cage and wheels I ran into SERIOUS jamming issues.
And also if you run half-lengths, this probably needs a stronger pusher return spring.
installation guide:
(photos coming soon, probably)
1. unscrew blaster
2. remove the cylinder
3. (optional but heavily recommended: move stock flywheels and motors into the replacement flywheel cage mentioned earlier)
4. replace the stock pusher with the printed pusher
5. cut off the cam advancer on the trigger (the lower rod behind the cylinder)
6. cut off the little triangle shape of plastic on the underside of the cylinder housing, but don't throw that bit away yet
If you're using the half length fileset:
1. put a spring in the hole in the mag release, then try and line the spring up with the hole in the magwell.
2. pressing the mag release against the magwell, try to run the printed pin through the hole in the magwell and through the mag release.
7. slide the magwell into the spot where the cylinder was
If you're using the full length fileset:
1. drill two holes into the shell that line up with where the holes near the back of the printed piece are (maybe use a marker or something)
2. install the two leftover screws from the triangle shape you cut off earlier and adjust how far they stick out until it works nice as a mag detent.
10. load up a mag and enjoy your budget stryfe!
updates n stuff
7/4/26: Made the hole for the mag slightly bigger.
7/5/26: Added a replacement pusher to hopefully help with jamming.
7/16/26 Added a half-dart version. (This, with stock motors and wheels, does have FPS issues due to less contact time between the flywheel and the dart. I would recommend upgrading the motors if you print the half-dart version.)