Helldivers 2 Stratagem Orb - Opens and Closes

I have printed this before (on a low quality printer) and it worked well, I just don't have the orb right now

^ printed on the Prusa Core One+, went flawlessly, though I recommend actually printing the "base" round side down, as removing the supports from the interior side was cumbersome, and the outside is much easier to sand

THIS THING IS MASSIVE, I highly recommend scaling down to 65%, its larger than a softball at full size, use m2 socket head screws at this %

the design splits the "petals" of the orb into 2 halves for easier printing with less supports, they need to be glued together

it is designed to attach the "petals" with either an m4 or m5 socket head bolt, no nuts needed, I will update the post when I verify the m#

please do print at 65%, m2's fit perfectly and it can open and close with just the right resistance to keep its position a little, so no floppy petals

If people request it, I can "core out" the inside of the base to allow for LED's to be inserted for display purposes