1 / 11
autodry 2000 (Herb Drying Box) — image 1
1 / 11

autodry 2000 (Herb Drying Box)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Drybox for your Herbs.

Rating
0 / 5
Likes
5
Downloads
11
Makes
0
Views
162
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

Autodry 2000

This is my DIY solution for drying plants after harvest.

The enclosure is built around a 40 × 60 × 30 cm Eurobox with a matching lid, with most of the custom parts being 3D printed.

Electronics used:

  • DHT22 temperature/humidity sensor

  • ESP8266

  • 12V to 5V DC converter

  • 12V PWM fan controller

Fresh air enters through a passive intake at the bottom, while a fan exhausts air through the top. To ensure even airflow, I added a simple air diffuser made from a small wooden plate.

The ESP8266 continuously monitors the temperature and humidity, calculates the target humidity based on a VPD formula, and automatically adjusts the fan speed to maintain the ideal drying conditions.

If the target humidity can't be maintained for an extended period, the system shuts down and sends a notification, reminding me to check whether the harvest is ready.

I've used it for two drying cycles so far, and the results have been much better than I expected. Room temperature and ambient humidity still influence the process, but the inside of the box typically stays about 2°C cooler than the room while maintaining a stable humidity level throughout the drying process.

I'm really happy with how it turned out!

Enclosed two logs of my first tests with the box. The first one we had a heat wave with over 30 deg C. On the second one I think the amount was a bit too little and it humidity in the room was quite dry (around 30% rh) most of the time.

Tags