Sapphire Plus Mosquito Hotend Mount with ABL Support by ideagen3D
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remixed from R31L4ND's E3D V6 Hotend Mount for the Sapphire Plus to better support the Mosquito/Spider & clone…
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 51
- Makes
- 0
- Views
- 540
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Remixed from R31L4ND's E3D V6 Hotend Mount for the Sapphire Plus to better support the Mosquito/Spider & clone hotends.
The collar and BLTouch mount have not been changed - feel free to re-use R31L4ND's.
BLTouch: define NOZZLE_TO_PROBE_OFFSET {0, -43, 0 }
Static: define NOZZLE_TO_PROBE_OFFSET {0, -48, 0 }
Summary of changes:
Reduced length of ducts (Mosquito Hotend is slightly shorter)
Increased "height" of the 2 slots on top where you can drop nuts into, increases compatibility with thicker nuts.
Added a mount for static ABL Probes (Inductive or Capacitive), 12mm diameter probes.
Added a reinforcement bar to minimize flex when printing at super high speeds and avoid breaking during installation.
Added optional 5 mm 'spacer blocks' - the mosquito hotend is noticeably taller than the stock, so depending on your bed and where you've mounted the Z endstops, even maximally tightened screws may not be enough. If this is you, stick this spacer block with double-sided tape to the bed brackets underneath Z endstops. You will need 2 of these, 1 for each side.
Print Settings
Printer:
Sapphire Plus
Rafts:
No
Supports:
Yes
Resolution:
0.24
Infill:
25%
Filament:
ideagen3D PETG
Orange
Category: 3D Printer Accessories