1 / 5
Voltage Regulator Jiffy Box
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Circuit Board box with wire holes and clamps. Requires 4g screws 6-10mm
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 43
- Makes
- 0
- Views
- 294
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a Jiffy box I designed for my voltage regulator I got from Jaycar (XC4514) can probably be adapted for nearly any small circuit board. I printed it in Clear as the board has an LED on it. I used Low Quality 0.28mm height 100% fill. After my first draft I realised that when I put screws in the screw poles can break off so i reinforced them. Using a tougher material than standard PLA would probably help as well. I used 4Gx6mm screws.