Garden Water Splinker
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
garden sprinkler irrigation watering hose outdoor garden PETG PLA
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 6
- Makes
- 0
- Views
- 48
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Assembly and material notes
The sprinkler consists of two parts. The lower part is the bottom cover and must be permanently glued into the main body.
A tight fit with minimal clearance is strongly recommended. This joint is exposed to water pressure. If the bottom cover is loose or insufficiently glued, water pressure may push it out.
I successfully printed the model in both PLA and PETG and did not notice a significant difference in strength. However, with my printer settings, the PETG version had a larger clearance between the two parts, while PLA produced a tighter fit.
The inlet connector is designed for a 1/2-inch garden hose with an approximate inner diameter of 16 mm, as shown in the photos. The hose fits securely and stays firmly in place without a hose clamp.
Before gluing, test-fit the two printed parts. Apply waterproof adhesive around the entire joint without leaving gaps and allow it to cure completely before connecting the sprinkler to the water supply.
Printer tolerances and material shrinkage may vary.