Raspberry Pi 3A+ case with fan
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.28 – €0.35 net (excluding VAT)
For file: fanHolder_0.2mm_PLA_MINI_24m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.32 excluding VAT (range midpoint).
- Weight reported by the author
- 2 g
- Print time reported by the author
- 24.6 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A ventilated case for mounting a Raspberry Pi3A+ to a Prusa printer
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 164
- Makes
- 0
- Views
- 1,070
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
Housing for installing a Raspberry Pi3A+ to a 3D printer. On the shown pictures it is mounted to a Prusa Mini. Although the documentation for Octoprint does not explicitly recommend the A model, it is quite capable of doing the job and requires less space than the B model.
The Model consists of two main pieces that are held together when the case is mounted on the Y-axis extrusion and an optional third piece that snaps into the lid and allows mounting a 30mm fan. The height of the lid also allows mounting a 6mm heatsink on top of the processor.
Notes for printing:
Both the Bottom and Lid parts require supports on the outside to hold the section that holds them in place when mounted on the extrusion.
Notes for assembly:
It is important to note that the optional fanHolder piece must be inserted in a specific orientation into the Lid and the fan should be positioned and placed on it BEFORE snapping it into place.
For mounting the case to the printer, join the top and bottom pieces, insert them into the extrusion, and rotate them 90 degrees to lock them into place.