MG955 Servo Robot Arm
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A robot arm that is very good and usefull
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 10
- Makes
- 1
- Views
- 189
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Assembly
This robot arm is designed to be assembled with heat-set inserts and screws.
Hardware needed:
~15 × M2 heat-set inserts (used for all parts except the base)
3 × M3 heat-set inserts (for the base)
M2 × 6 mm screws
M3 × 6 mm screws
M2 nuts
M3 nuts
M3 × 20 mm screws (for the gripper)
To assemble the arm, install the heat-set inserts into the printed parts, then attach each section using the appropriate screws and nuts. Most of the assembly uses the 6 mm screws, while the 20 mm M3 screws are used for the gripper. Once all the parts are fastened together, the robot arm is ready for the motors and electronics.