Elko Plus AC remote holder - Anslut portable AC remix
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
AC remote holder that clips onto an Elko Plus outlet or switch frame (needs blinding plate or dimmer in top hole)
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 1
- Makes
- 0
- Views
- 24
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
AC remote holder that clips onto an Elko Plus switch frame or outlet (needs blinding plate or dimmer in top hole)
I printed the model made by 3D.Nystad https://www.printables.com/model/389408-elko-plus-attachment-ac-remote-control , it works well even on a elko plus switch frame, caveat being that you need a blinding plate (pictured) or a dimmer (untested but should work) on the top box. However I have a smaller controller, so I adjusted the dimensions and removed the hexagonal pattern in prusaslicer (I just shrunk everything where needed and added flat “slabs” to overlap onto the hexagonal pattern (to remove it)
My remote in question is 110x50x20mm ish, if your remote control works with this then this will work as well
One note, with the removal of the hex pattern I also removed the ability to have organic supports that attach to the build plate, the hex pattern is still there but squashed (not visible if you don't restore it) due to shrinkage so you can delete it if wanted in prusaslicer or whatever slicer you use (I used the cut tool in prusaslicer and all the parts were listed)
I used Prusament PLA Pristine White, matches the Elko polarhvit almost perfectly