1 / 1
Enhanced AR15 Trigger Guard
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An enhanced trigger guard for the AR15 platform.
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 80
- Makes
- 0
- Views
- 315
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
An enhanced trigger guard for the AR15 platform. It is designed for standard AR15 lowers. It should fit all receivers with a removable trigger guard, but the lines might not match up.
Orientation:
Print on it's side.
Settings Used:
Material: PET-CF
Layer Height: 0.12mm
Wall Line Count: 5
Infill Percentage: 100%
Support: Yes
Required Hardware:
1x 1/8 x 5/8 Trigger Guard Roll Pin
1x 8mm-10mm M3 Set Screw
Installation:
Use a 1/8 x 5/8 roll pin in the rear hole, and insert a M3 set screw in the forward hole and thread it in so it is flush with the receiver tab.