XFX Swift RX 9070XT Noctua adapter

Adaptor Plate to mount 3 Noctua Fans (2x NF-A12x25 and 1x NF-A9) to a XFX Swift AMD Radeon RX 9070XT Triple Fan Gaming Edition .
Uses original mounting holes and screws from stock fan assembly for mounting on the cooler. 

Stock cooler can be removed without complete disassembly. Mounting Screws can be accessed through the fan blades of stock fans. 

Print the plate from PETG or ABS to prevent warping under high loads.
Additional hardware:

• 8x M3x3x5 heatinserts (https://www.amazon.de/dp/B0DCBTHS7D?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1)

• 8x M3x30 countersunk head screws (https://www.amazon.de/dp/B0FW4LNR4Z?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1)

• 3 to one fan cable

• (optional - GPU fan header adaptor cable https://www.amazon.de/dp/B01MQOGCFV)

Assembly.

1. Print the adaptor plates.

2. Remove the stock Fan assembly by unplugging the fan connector form the GPU and unscrewing the small 6 phillips screws through the fan blades

3. mount the heat inserts flush with the top layer of teh print

4. Snap the adaptor plate together at teh dovetails

5. Place the adaptor plate on the cooler (bottom layer of the print on the cooler) and use teh original screws to fasten the adaptor plate

6. Position the fans over the mounting heat inserts (120mm fans on the outsides)
   I recommend routing teh fan cables in teh opposite direction of the PCI conenction - same side as the power connector)

7. Tighten the fans down wiht the countersunk screws (dont over tighten them)

I use a 3 to one fan adaptor cable and an extra fan header on my motherboard, controlled by Fan Control. If you want to use the original GPU fan header you need another adaptor cable for the GPU fan header like (https://www.amazon.de/dp/B01MQOGCFV)