Galaxy S26 Ultra Charging Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
S26 Ultra charging stand with 25W quick charger pad and pen holders. Holds phone at 30° angle with audio guides.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 43
- Makes
- 0
- Views
- 249
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial
S26 Ultra phone charging stand provisioned to accommodate 56mm x 5mm 25 watt quick chargers. Added audio guides to bottom for better sound broadcast and microphone reception. Also contains a couple pen/marker holding provisions at the top.
Designed for the OtterBox Defender Series Pro Case that contains the magnetic ring. I'm not certain if other cases will be sized to perfectly align charging pad with magnetic ring, you may need to adjust model accordingly.
Quick charger referenced for this design was found on Amazon
Printed from PLA with .2mm layer height. No supports needed.
Attached G-Code file is for the Prusa XL, no input shaper. Smooth PEI Build Sheet.
I used silk-silver PLA found on Amazon
Apply 6 small patches of double sided tape, anything considered light to medium duty between 3mil to 10mil thick works well to retain the charging pad. Or a few spots of adhesive will do.
Model is provisioned with cable routing underneath and can accommodate pass-through of 15mm wide USB-C cable ends. The charger above has an approximately 3.3mm diameter cable that routs neatly around the retaining features in the slot underneath and out the back.
