Profile 4040 Power Supply holder - 5V 12A - for OctoPI/LEDs
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This thing came about due to my need to not have my Meanwell type power supply (5V 12A PSU), which I use to power my…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 14
- Makes
- 0
- Views
- 280
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This thing came about due to my need to not have my Meanwell type power supply (5V 12A PSU), which I use to power my OctoPI and LED strips, lying about separately from my 3D printer.
It is mounted to the 4040 extrusion on the lower right side of my Ender 3. You would need to slide the holder in onto the 4040 extrusion just deep enough to allow for the original end cap to be replaced back onto the end of the extrusion.
Just be mindful of the X-gantry and leave a gap for that when at the lowest point so as to not obstruct it.. you might need to cut away some of the back most “sliders” to fit the 4040 cap.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
20%
Filament: Any PLA / Any any
Notes:
Print upright with a brim and supports touching build plate option for the rails.
Category: 3D Printer Accessories