Prusa Core One / + Improved Side Dust Protectors (Non-Visible Gap)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Moved the gap between the 2 halves much further back, to make the large seam invisible. Now it looks more professional.
- Rating
- 5 / 5
- Likes
- 47
- Downloads
- 109
- Makes
- 2
- Views
- 706
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This model is directly based off of dancan13f's Dust Protectors, but greatly improved.
The only issue I had with the original dust protectors is that the version that would fit within the Core One is split right in the middle. That split is super visible and if you look at makes of the model, you can tell exactly who made the split model and who didn't. But you can't print out the full version, since it won't fit on the Core One's print plate.
Now you can print this protector within the confines of your Core One, but without the ugly gap. The best of both worlds.
I took the necessity of it fitting on the print plate, and mixed it with the good look of the uncut piece that won't fit on your print plate.
With this new design shown above, the split moves into the back corner, which makes it invisible once installed.
Here is the old design, which has a center-split.
Keep in mind! The small piece with the rounded inside corner connects to the LEFT side., and the small piece with the sharp inside corner connects to the RIGHT side.
As seen below.
