1 / 5
Playmobil 3666 Castle Straight Stone Wall – Replacement Part 3007612 — image 1
1 / 5

Playmobil 3666 Castle Straight Stone Wall – Replacement Part 3007612

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a 3D-printable replacement for PLAYMOBIL part 3007612, the straight stone wall panel

Rating
0 / 5
Likes
4
Downloads
34
Makes
0
Views
104
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

This is a 3D-printable replacement for PLAYMOBIL part 3007612, the straight stone wall panel used in the classic PLAYMOBIL castle construction system.

The original part can be found in vintage medieval castle sets such as PLAYMOBIL 3666 and is also compatible with other classic castle sets that use the same wall system, including 3665 and 3667.

I tried to keep the model as close to the original part as possible. However, I made one side fully flat, with the exception of the recessed grooves that define the individual stone bricks. This change makes the part considerably easier and more reliable to print while preserving the original brick-wall appearance.

The dimensions, connector positions and general shape were designed to match the original wall as closely as possible. Because printer calibration and material shrinkage vary, minor sanding of the connection points may occasionally be required.

The download includes:

- STL file for use with any compatible slicer

- Optimized 3MF project with the recommended orientation and print settings

- High-quality brick and stone surface detailing

- Functional connection points for the classic castle wall system

This is a fan-made replacement part and is not an official PLAYMOBIL product. PLAYMOBIL is a trademark of its respective owner.

Digital files only. No physical product is included.



## Settings and manufacturing instructions

Print the model in the supplied orientation with the flattened rear face against the build plate.

Recommended settings:

- 0.4 mm nozzle

- 0.08 mm layer height

- 0.20 mm initial layer height

- Arachne wall generator

- 3 walls/perimeters

- 9 top layers

- 7 bottom layers

- 12% gyroid infill

- Supports enabled

- Normal automatic supports

- Snug support style

- Supports placed everywhere, not build-plate-only

- 30° support threshold

- 2 top support-interface layers

- 0.16 mm top support distance

- 0.30 mm support-interface spacing

- 0.45 mm support/object XY distance

- 8 mm outer brim

- 0.10 mm brim/object gap

- Approximately 60 mm/s outer-wall speed

- Moderate acceleration for improved surface quality and dimensional accuracy

PLA or PLA+ is recommended for the easiest and cleanest print. PETG may also be used, although it can make support removal more difficult and may require additional clearance around the connectors.

Clean the build plate before printing. The 8 mm brim is recommended because the wall is relatively long and can otherwise lift slightly at the corners.

Allow the model to cool completely before removing it from the build plate. Carefully remove the brim and support material without applying excessive force to the smaller connection features.

Test-fit the wall gently. When minor adjustment is required, lightly sand only the affected connector surfaces rather than scaling the entire model.