1 / 11
Case for Lilka v2 — image 1
1 / 11

Case for Lilka v2

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A compact case for Lilka v2

Rating
0 / 5
Likes
2
Downloads
6
Makes
0
Views
42
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

A compact case for Lilka v2. The goal was to make it as slim as possible while fitting as much battery capacity as possible.

The SD card is not mounted directly to the board and is connected via wires, allowing the battery to sit closer to the board. Silent 1.4H 12 mm tactile buttons with TPU button mounts make the buttons quiet, with an old-phone-like feel.

The TPU parts can be replaced with plastic; only the thin interconnecting tabs need to be cut.

Note: Does not have an extension connector or a 3.5 mm jack.

Not printed parts:

  • 6× M2.6×12 screws (case)

  • 2× M2×4 screws (SD card board)

  • LP503759-PCM-LD battery (or compatible, 59 × 37 × 5 mm)

  • B3F-5000 buttons (or cut the ones from the kit)

Recommended settings:

  • Material: PLA (TPU optional, for button mounts)

  • Layer height: 0.16 mm

  • Infill: 15%

  • Perimeters: 1 perimeter for the first layer (use your normal setting for the rest)

  • Bottom surface pattern: Hilbert Curve

  • Fuzzy Skin: Enabled on the outer perimeter

  • Supports: Required for the SD card slot

Use your slicer's default settings for everything else unless you have specific preferences.

Original project: https://github.com/lilka-dev/lilka

Tags