HP HDD drive mounts/holders/screws - rubber isolated
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Those are hdd drive mounts that are used to fit drives into HP pcs. Three models, m3 screws.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 3
- Makes
- 0
- Views
- 33
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- GNU General Public License v3.0
Those hdd mounts are made for HP desktops. Three models,.
There are three variants, however specifically one version is made so it isolates the disk vibrations, so they do not spread further in the case to minimize noise and vibrations. Use cut kitchen rubber as illustrated in the photos. Circle the rubber around the screw between disk and mount and the between screw and mount.
*screw length | fits rubber | |
|---|---|---|
rubber-isolated | 10mm | yes |
hdd-mount 6mm | 6mm | no |
hdd-mount 8mm | 8mm | no |
*screw length is the total screw length like for sink screws. This length is safe not to demege any insides of the drives
Note when I was modeling and printing I haven't had any drive screws, but the m3 screws worked just fine. I made the holde big enough to pass even bigger screws comfortably