Quest Golf Putter

This is a complete redesign golf club attachment from my last model. I made this to use less unique hardware and be more compact. It has grip to putt feature, trigger pull for teleporting, and access to the thumbstick and buttons without having to let go of the club handle. It's quick to put the controller in and be playing. It also has a place to attach weights to the club and a soft TPU bumper that can be attached to the end of the club to protect walls from accidental hits. I have been printing in PBT and PET, but PLA should work fine (just don't over tighten screws to strip out holes).

A short video of the controls: 

Assembly: Hopefully the pictures show for the most part. The 'Main body holder' part will need to be glued on the main body. This is so you don't have to print with any supports (no supports needed on anything). The trigger button is tied to the lever with a piece of TPU filament and can be adjusted for tightness, but you could also use string. The swing arm lever is attached with a piece of filament, as well as the grip trigger that presses the grip to putt button. If this part doesn't move freely move it back and forth several times to loosen up the filament that may have a slightly large diameter. The flexible arm going to that lever is thin and may wear out or lose shape over time, but so far I've not had a failure. It may also be a bit stiff at first and need working in and out to loosen it up.

If anything doesn't make sense please feel free to ask. Also I'm open to tweak ideas and suggestions to make it better!

Parts you will likely need:
1/2" long 5mm or 3/16" cap head screws x2 (for the trigger and thumb levers. 
1/4" Hex nut x2 (one for main body and one for bumper)
(All these bolts are 1/4")
2" hex bolt (for main body)
3/4" hex bolts (for weights, depends on thickness of your weights. There are 4 open sides on the block)