1 / 2
FlashForge Creator 5 Extended Spool Holders (8cm)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A replacement spool holder for extra thick filament spools
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 25
- Makes
- 0
- Views
- 118
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a replacement Spool holder for the Creator 5. It adds about 1 cm of length, allowing you to use spools of larger size.
Two variants are included — one for the left side and one for the right side. You can omit one of them if you only need to accommodate a single Spool on your machine.
I would suggest using PETG for better strength.
The model can likely be printed without supports, but I printed non-sticking support interface regions to create a cleaner tunnel for the bolt and alignment notch.