1 / 10
Drained tray for oval hand soap pumps — image 1
1 / 10

Drained tray for oval hand soap pumps

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A self draining 2-part tray for oval Soap pumps. An upper perforated part and a bottom sloped part with a open drain.

Rating
0 / 5
Likes
3
Downloads
2
Makes
0
Views
33
Reviews
0

Updated at source:

Model information

Category
Bathroom
License
Creative Commons — Attribution — Noncommercial — Share Alike

We have soap pumps by the sink on our bathroom wash basins. Naturally they are often used with wet hands, causing drops of water running down the canister and assembling around its base. Causing in its turn dirt and particles to collect around it. Not a big problem, but we like to keep it nice and tidy.

I made a tray which is sloped against an open drain in the low end, making it self-draining. And an upper perforated tray to put the canister on that lets the water droplets run through down to the sloped tray below.

The soap pumps we use are oval in shape, so I made the trays in the same shape. The soap pump canister we have is elliptical in shape, with a width of 76 mm by 54 mm. So if your soap pumps have a different size you might need to scale the print up or down based on these widths.

I printed the bottom tray in White TPU to get a bit more friction against the wash basin. But getting the supports off from a TPU object is a bit of a pain I discovered. I tried both linear and tree like supports, both with a brim. I think the Tree like supports was easiest to remove. But the linear supports gave a better and more even bottom surface. In both cases I had to use pliers, a sharp mat knife, file and my grinding mouse to remove the supports. So for the best print result I would recommend linear supports.

In my slicer software I rotated the tray about 2,5 degrees “backwards”, to get a completely flat/horizontal upper surface without any joint lines from when the print head changes direction. And also to reduce the amount of supports as much as possible.

The upper tray I printed in White PLA Tough+, in up-side-down position so no supports were needed. The upper tray has a small arrow in one side, which shows where the low end is and should be pointed towards the drain.

Tags