1 / 12
NStrike Magazine Adapter Pack: Talon, Angled Talon, Nightingale — image 1
1 / 12

NStrike Magazine Adapter Pack: Talon, Angled Talon, Nightingale

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

NStrike Magazine Adapter Pack: Talon, Angled Talon, Nightingale

Rating
0 / 5
Likes
26
Downloads
46
Makes
0
Views
386
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Description:
This set contains magazine adapters that allow you to use Talon, Angled Talon, or Nightingale magazines with your stryfe or other NStrike magazine blaster. A short dart pusher is still required to properly fire the darts.

Materials (Per Adapter):
Talon: Pushes the magazine all the way forward
* 2x M3x6mm Machine screw - Needs a relatively thin head so it does not stick out the side of the adapters
* Spring: 0.02x0.24x0.59 (0.5*6*15mm), 12 laps

Angled Talon: Pushes the magazine all the way forward, also takes nightingale magazines!
* 2x M3x6mm Machine screw - Needs a relatively thin head so it does not stick out the side of the adapters
* Spring: 0.016x0.2x0.79 (0.4*5*20mm), 13 laps

Nightingale: This sits a bit back in the magwell - if you're having trouble with your pusher handling the Angled Talon adapter, try this.
* 2x M3x6mm Machine screw - Needs a relatively thin head so it does not stick out the side of the adapters
* Spring: 0.016x0.2x0.59 (0.4*5*15mm), 10 laps

* Pen springs may work fine as well

Printing Instructions:
You will need supports. I recommend PETG with 3 walls and 15% gyroid infill, but PLA should be fine.

Installation Instructions:
If you do not already have a short dart pusher, I did most of my testing with the V2 daybreak pusher in this pack.
Short Dart Pusher - Makerworld
Short Dart Pusher - Printables

1. Print the parts for the adapter of your choice. Be sure to smooth out rough edges - especially on the outside of the lever block and in the notch for the blaster magazine catch. The adapter intentionally has a tight fit in the blaster, so any extra material can cause problems.
2. Add the lever to the lever block.
3. Retain the spring in the hollow between the lever block and the lever.
4. Insert the lever block through the top of the magazine body and push down until the screw holes line up.
5. Secure the magazine body to the block with the M3x6mm screws. Be sure the head does not stick out past the counterbore or the adapter may not fit in the blaster.

Testing method:
These adapters were all tested across 4 Nerf Stryfes with different pushers, using both 2S and 3S power. Darts were mostly very worn - some were even sliced or torn.

Tags