1 / 7
Clip-On Elvis Sideburns — image 1
1 / 7

Clip-On Elvis Sideburns

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Clip-On sideburns for those special occasions.

Rating
0 / 5
Likes
1
Downloads
6
Makes
0
Views
35
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

If you need them, you need them. These easy to print sideburns clip onto your glasses to give that classic vibe.

Printing is simple. 0.4 nozzle, 0.20mm Speed, 4 perimeters, no supports. 0.20 keeps the sideburns thin and pliable at 0.40mm total thickness. The 4 perimeters ensure the clips are solid.

Use PLA or PLA+ to make forming the curves easy after supergluing the clips to the sideburns. The clips are glued to the outside of the sideburns to keep the sideburns close to your face.

You may need to resize the groove width in the clips to snugly fit your frames. Adjust the X dimension to suit, then cut any excess if needed to avoid overly thick walls. The original design is 2.4mm thick walls with a 3.5mm groove width. Shimming the inside of the clips with tape works for fine adjustments. Check the pictures for examples. Very thin wire frames will not hold the sideburns vertically and close to your face, but then again, The King didn’t wear wire frames.

To form the 3D curve I found a vase shaped perfectly for the task. Using a heat gun on Low, warm the assembled sideburn until soft and quickly lay it on the vase, gently stretching the PLA+ to shape. If you get wrinkles reheat and try again. Slightly preheating the vase may help.