Speedy Stitcher Bobbin - No Supports
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Prints in two halves without supports, finished with M2 and M4 hardware you probably have lying around.
- Rating
- 5 / 5
- Likes
- 1
- Downloads
- 5
- Makes
- 1
- Views
- 33
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a more printable version of a bobbin for the Speedy Stitcher leather/canvas/webbing sewing tool. Instead of printing the axle, an M2 screw is used on each end. This lets the part be split in half and printed with the widest point on the bed.
Print two copies of the STL, wide end flat down on the bed - they're identical - and run an M2 x 10mm countersunk screw through the bottom of the bore until it sticks out 2-3mm. Then run an M4 x 6 grub screw halfway into the top of one bore, and thread the other half's bore down on top of it.
You might have to clean out the M4 section with the grub screw to get the head of the M2 screw down into its section.