1 / 2
Dust shoe to fit Genmitsu 3020 Pro Ultra and similar — image 1
1 / 2

Dust shoe to fit Genmitsu 3020 Pro Ultra and similar

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Genmitsu's official accessory is flawed -- it restricts the air flow as it is raised up on the motor body.

Rating
0 / 5
Likes
4
Downloads
15
Makes
0
Views
81
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Share Alike

Genmitsu's offering for this machine is too restrictive, especially when mounted high to accommodate short tool bits.  This maintains full air flow at the cost of transparency. It works very well carving wood and restricts the radius of flying chips when milling aluminium -- but metal is heavier and some cuttings fall to the table. 

The bristles are purchased from Amazon or similar in a roll then cut to length and glued in with hot-melt glue. I initially designed an inner "brush retainer" ring to secure things with plastic screws, but there is not enough clearance between the back of the router body and the Z axis mount. So that ring can be used as a temporary clamp while glue sets, but must be removed before actual use. 

The shoe is connected to the motor in two pieces. A "motor clamp" ring clamps the motor at the desired height. It is clamped with an M3 socket cap machine screw and an M3 heatsert. The brush portion has two clasps, one for each side. They use a total of 4 M3 x 20mm screws for hinge and latch pins. (my own design, but not an original idea -- tip of the hat to Whity's Rugged Box design). 

The vacuum hose port is 30mm diameter and tapered to fit a hand-held router dust hose. Other hose sizes will require an adapter or some custom modification to the design file. 

Printed in Tough PLA with lots of walls. 5 or 6 IIRC. 

Tags