Crealty SpacePi X4 PTFE Tube Stop
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mounts PC4 fittings to prevent PTFE/Bowden tubes from being pulled into the dryer.
- Rating
- 5 / 5
- Likes
- 16
- Downloads
- 76
- Makes
- 2
- Views
- 361
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This threaded stop for PC4 fittings prevents your PTFE / Bowden tubes from being pulled into a Crealty SpacePi X4 filament dryer. Each stop uses two PC4 fittings. Models are included for PC4-M6, PC4-M10, and PC4-01 NTP fittings. It's held in place by the tubes and fittings.
After screwing in the fittings, it helps to insert both tubes to the desired lengths before pushing them through the filament dryer ports. Putting PFTE tubes through the back of PC4 fittings can be fiddly, and you have to press down the release while feeding. Alternately, you can feed the whole tube through the front, or use a razor to put a small chamfer on the end of the tube to make insertion easier.
A Fusion 360 file is included if you want to modify the design.
PLA with 2 borders and 0.2mm layer height works fine, any infill. The stop in the photo was printed on a smooth plate with 4 borders on a Prusa MK4S and has PC4-M10 fittings.