1 / 2
Crosswalk Traffic Light - Arduino Housing (Pole, Base & Pedestrian Covers) — image 1
1 / 2

Crosswalk Traffic Light - Arduino Housing (Pole, Base & Pedestrian Covers)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

3D printed housing for an Arduino crosswalk traffic light. Print 2 sets for a complete crosswalk.

Rating
0 / 5
Likes
2
Downloads
33
Makes
0
Views
115
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

What is this

A 3D printed housing for a fully working crosswalk traffic light controller built with an Arduino Uno, LEDs and push buttons on a breadboard.

Each pole contains three sections: car traffic light (top), pedestrian light (mid-height) and push button housing (base). Wires run through the inside of the pole and exit at the base.

Print 2 sets for a complete crosswalk.

What's included (per pole)

  • Pole: car lights, pedestrian lights and button housing in a single piece

  • Pedestrian light covers: walk and stop signs that go over the pedestrian LEDs

  • Base with JST XH connectors: clean separation between pole and wiring

  • (alternative included on STL files) Base simple: plain hole for wires, no connectors needed

Tip: print the pedestrian covers in white or a light color, the LED needs to shine through. If you have a multicolor printer, printing only the sign drawing in white gives a great result.

Electronics required

Per pole:

  • Red LED × 2, Yellow LED × 1, Green LED × 2

  • 220Ω resistors × 5

  • Tactile push button × 1

  • Jumper wires (colour-coded recommended): red, yellow, green for LEDs; black for GND; blue for buttons

Shared between both poles:

  • Arduino Uno R3 (we used Elegoo Uno R3)

  • Breadboard

Optional (for clean wire separation):

  • JST XH 4-pin housing + receptacle × 1 per pole

  • JST XH 3-pin housing + receptacle × 1 per pole

Code and guide

Electronics code and full wiring reference on GitHub:
github.com/MitsuMira/maker-projects

Full assembly guide with wiring diagram and step-by-step instructions:
mitsumira.com/proyectos/semaforo/

Print settings

  • Material: PLA

  • Layer height: 0.2 mm

  • Infill: 8%

  • Supports: no

  • Colors: black (pole and base), yellow (button and light housings), white (pedestrian covers)

Printed on: Snapmaker U1

Designed and tested by MitsuMira in Barcelona.

Tags