CKCS 4 x 65W PD 3.0 Charger Case (usb c)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Case for 4 channel charger board that can be find on Aliexpress . Make sure that the first layer is not over-extruded!
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 27
- Makes
- 0
- Views
- 117
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
This is a slim case for 4-way pd/qc charger that can be found on Aliexpress for very cheap. It is approximately 30g in total with PLA. There will probably be another version of this soon. Initially, it doesn't require any screws, but front cover should be glued. I'd recommend phone repair adhesives like T-8000 but there are other adhesives that can work too. Also, while printing this version, make sure that the first layer is not over-extruded, because since the tolerances are low, it would block type-c sockets from going in.
