Multiboard adapter for Parkside Organizer (315x415x135) IAN 515829
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Multiboard adapter for Parkside Organizer (315x415x135) IAN 515829
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 2
- Makes
- 0
- Views
- 96
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Public Domain
When printing the model, you need to have bed that is 256x256, and then align the adapters diagonally in the slicer(rotate for 45 or 135 degrees), because the length od the adapter is 330mm.
Adapter should be aligned so that the holes are looking down. And holes are getting narrower, deeper they go. And thus, the adapter doesn't need any kind of support.
First you need to attach 6.25 mm - Offset Snap (DS Part A) to the back of the multiboard.
You do that by attaching every second hole vertically - for left adapter, horizontal spacing between two adapters of 3 holes, and then again every second hole vertically - for right adapter.
Top INNER sides of adapters are marked with second hole on the side, next to the regular hole. So marking on the holes needs to be on the top, and more towards the centar.
I used Spax torx screws (4x16) to mount backplate of the organizer to adapter:
https://www.amazon.de/-/en/T-Star-Universal-Countersunk-Screw-Thread/dp/B0B6FYVXM1
and then attached the box to the backplate, and put the drawers back in.