M.2 2230 -> 2260 Extender Bracket V3 — PLA tuned
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Target: Kioxia/Toshiba KBG40ZNS256G M.2 2230 NVMe Key dimensions - Internal/body width: 22.50 mm - Overall length: 64.0
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 14
- Makes
- 0
- Views
- 66
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Public Domain
M.2 2230 -> 2260 Extender Bracket V3 — PLA Tuned
Target:
KIOXIA / Toshiba KBG40ZNS256G
M.2 2230-S2 NVMe SSD
Official target SSD dimensions:
30.0 × 22.0 × 2.23 mm
Key dimensions
- Internal/body width: 22.6–22.8 mm recommended for PLA
- Overall length: 64.0 mm
- 2260 mount center: 60 mm
- Mount centers: 30 / 42 / 60 mm
- M2 clearance holes: Ø2.40 mm
- Base thickness: 1.0 mm
- PLA lateral clearance:
approx. 0.30–0.40 mm per side relative to a nominal 22.0 mm SSD
V3 retention concept
The transverse bridge is edge-biased.
Low retention lips contact only the PCB edge areas.
The center section is raised so it does not press against SSD components.
- SSD maximum module height: 2.23 mm
- Recommended raised-center underside clearance:
approximately 2.50–2.60 mm above the SSD support datum
- Edge-lip clearance should be tuned against the actual PCB edge thickness.
~0.8 mm PCB thickness is a design assumption and should be verified physically.
PLA starting settings
- Layer height: 0.20 mm
- Walls/perimeters: 3–4
- Infill: 20–30%
- Print orientation: flat
- Supports: normally unnecessary
- Inspect retention bridge in slicer before printing
- Optional brim: 3–5 mm
Important
Test-fit gently.
Do not force the SSD below the retention lips.
Real FDM dimensions, PCB thickness and component placement can vary.
If the fit is too tight, increase the relevant SCAD clearance by
0.05–0.10 mm per revision.