Anemometer HP-5000D Funnel 210mm
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Funnel for not expensive anemometer HoldPeak HP-5000D. It can be used to measure up to 200mm diameter pipes
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 3
- Makes
- 0
- Views
- 52
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
Funnel for not expensive anemometer HoldPeak HP-5000D. It can be used to measure air speed/volume on up to 200mm diameter pipes. I've used it to check my HVAC (recuperation) at house.
There are other funnels, sadly each of them (also this one) works only for a specific anemometer model.
There is a twist to open/close ring, to hold device in the funnel - works quite well.
Printing
Funnel can be printed without supports (wider side on the bottom) - but the window won't be the prettiest one you could get. I recommend to add a manual support there, only in the middle (like 2cm) of the window. It prints perfectly.
Ring doesn't require support, but has to be placed wider part on the table.
Mine, both parts were printed in PETG. I guess funnel can be printed in anything, ring requires some bending to assembly - so PLA can be a bit to stiff.
Assembly
You just have to twist the ring on the funnel from the top, should go relatively easy. The tolerance (gap) is only 0,15mm (on both side of the rail) - but it worked well for me on my Qidi Q2 printer.