Raspberry Pi Zero Stand, Stemmafied
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€3.21 – €3.92 net (excluding VAT)
For file: pi-zero-stand-stemmafied_0.15mm_PETG_MINI_4h11m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.56 excluding VAT (range midpoint).
- Weight reported by the author
- 34 g
- Print time reported by the author
- 4.18 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Display your Pi Zero on your desk with this simple yet useful 3D printed stand, now Pi Cam and STEMMA-QT mounts!
- Rating
- 0 / 5
- Likes
- 25
- Downloads
- 75
- Makes
- 0
- Views
- 813
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Share Alike
A slightly maximalist remix of the awesomely simple Raspberry Pi stand by Adafruit, for those situations where you just need ALL THE THINGS. Or, like, more of them anyway.
Original: https://www.printables.com/model/7260-raspberry-pi-zero-stand
Additions include:
- Pi Cam mount
- Requires some M2 mounting hardware to mount the Pi Cam
- Works with any Raspberry Pi Cam V1/V2 or layout-compatable clone boards
- Slots included to keep the flat CSI cable out of the way
- STEMMA-QT board or other M2/M2.5 board mounts
- Requires some M2 or M2.5 mounting hardware to mount boards
- Layed out in a neat 10mm x 12.5mm grid
- Magnetic foot mounts
- Requires M3 nuts, 5mm M3 spacers, and M3-screw mag feet
- Magnetic feet: https://www.adafruit.com/product/4631
- Rear pin-header slot
- Need to get at the header pins from the back? No problem! :D
Note: This was my first Fusion 360 project, so the F360 source file is a horrible mess. Apologies to the original author(s) for how heavily I butchered their original project file. 😂
Printing Notes
For FDM printers I recommend printing this one face-down with bed-only supports enabled. This makes for much more reliable mounting hole printing and the nicer surface finish doesn't hurt.
Test prints were done on a stock Prusa MINI+ with Prusament Clear PETG filament. Sliced with PrusaSlicer, 0.15mm QUALITY, flipped 185-degrees to print “face down”, with some minor cosmetic tweaks (hexagon infill, archimedian chord surface infill). Prints took about 4 to 4 and a half hours.